stamforum

stamforum
פורום בינלאומי לנושא סת"ם

Monday, October 31, 2011

widened Drill hole of the Titora


In the picture here, you see the top side of the titora (shel yad) what happened was the first drill was not exactly in the corner so a second more accurate drill hole was made. The gid is going in the hole (the second correct one) however it is being pulled a little on a slope into the first hole and immediately passing into the proper hole. According to the halacha that tifran needs to be straight (it seems that it is also pulling a tad to the right , until it later straightens up), is it kosher or needs to be fixed?
Thank you

4 comments:

  1. knot some gid around to connect the two stitches and it should be fine

    ReplyDelete
  2. This comment has been removed by the author.

    ReplyDelete
  3. the common practice in EY is as eli wrote to pull it towards the horizontal gid, either knotting it, or pulling it under the horizontal gid and then stiching in the hole, so that it enters the hole as close to the other gid as possible.
    Although I think that such a slight inaccuracy is not counted - as being not ribua b'tafran.

    ReplyDelete
  4. This comment has been removed by the author.

    ReplyDelete

Note: Only a member of this blog may post a comment.